11
To start the selected programme, press the “start pause”
button; the corresponding light stops flashing.
Only the “prewash/wash” pilot light stays on.
The machine starts operating.
8. At the end
of the programme
The machine stops automatically.
If the “rinse hold” option has been selected, the phase
light “end” is on to indicate that the water must be
emptied out before opening the door.
To do this first turn the programme selector dial to “O”
and then to drain programme 14 or spin programme
15
.
In this case reduce the spin speed by means of the
relevant button to adapt it to the fabrics to be spun.
Release of the lock is also indicated by the illumination
of the “end” light.
Turn the programme selector dial to “O” to switch the
machine off.
Remove the laundry from the drum and carefully check
that the drum is empty.
If you do not intend to carry out another wash, close the
water tap.
Leave the door open to prevent the formation of mildew
and unpleasant smells.
To Next Page
Loading...
Need help?
General
