To Next PageTo Next Page
Need help?Do you have a question about the BendPak V-MAX ELITE 7580V-601 and is the answer not in the manual?
General| Model | V-MAX ELITE 7580V-601 |
|---|---|
| Horsepower | 7.5 HP |
| Voltage | 230V |
| Maximum Pressure | 175 PSI |
| Tank Size | 80 Gallons |
| Pump Material | Cast Iron |
| Orientation | Vertical |
| Pump Type | Two-Stage |
| Type | Two-Stage |
| Phase | Single-Phase |
| Weight | 540 lbs |
Please read the entire manual before operation. Do not operate until you understand all dangers, warnings, and cautions.
Observe safety precautions due to high pressure and potential explosions. Keep hands/feet clear, area clean, and use machine correctly.
Ensure proper grounding to prevent shock hazards. All moving parts must be guarded before operation.
The safety valve protects against high pressure if the pressure switch fails. Check daily by pulling the ring.
The pressure switch starts/stops the motor based on tank pressure. DO NOT ADJUST SETTINGS; this will damage the motor and void the warranty.
Required before putting the compressor into service. Serious damage may result if instructions are not closely followed.
Water condensation in the tank can cause corrosion and weaken the tank, risking rupture. Drain daily or after each use.
Table lists common compressor problems, their possible causes, and solutions for efficient operation and maintenance.
Covers duration, what is covered, what is not covered, and responsibilities of warrantor and purchaser.
