Beninca BE.PROXY - BE.READ;BE.PROXY System Overview and Specifications; System Components; BE.READ Receiver Specifications; BE.PROXY Reader Specifications

BE.READ/BE.PROXY
This system for the reading and decoding of transponder is composed of:
- BE.PROXY, card reader to be applied to wall or on column.
- BE.READ, two-channel receiver for the decoding of cards.
- TEO CARD, transponder card, 55x85mm standard size
- TEO, transponder, key-ring shape.
- TO.GO2/4T, 2 or 4 channel transmitter with built-in transponder
One or two BE.PROXY readers can be connected to each BE.READ receiver, as shown in the
wire diagram, Fig.2.
A typical installation is shown in Fig. 3:
1 BE.PROXY, access (external)
2 BE.PROXY, exit (internal
3 BE.READ with remote control unit - WARNING: it includes the opening control relays. This
unit shall therefore be installed in a protected position to avert any tampering.
4 Automatic opening
Specications of the BE.READ Receiver
Power supply 24 Vac/Vdc
Outputs 2 channels Max load: 500mA-48Vac/dc.
Max distance between BE.READ/
BE.PROXY
40m by using a shielded cable
Number of card codes that can
be memorised
250
Protection class IP30
Operating temperature from -20°C to +70°C
Specications of the BE.PROXY Reader
Number of conductors 2
Indications LED and buzzer
Protection class IP54
Operating temperature from -20°C to a +70°C
Input/output functions, BE/READ receiver
1-2 Output, channel 1* (500mA-48Vac/dc max)
3-4 Output, channel 2* (500mA-48Vac/dc max)
5-6 Input, power supply, 24 Vac/Vdc (5-,6+)
7-8 Serial input for code receipt from reader.
*Outputs 1-2 are already factory preset as normally open contacts (N.O.). They can be
modied to a normally closed contact (N.C.) by following indications shown in the paragraph
”To change the NO/NC output contact”.
8
9