GENERAL CARE AND MAINTENANCE
SECTION
10
© 2003-2020 Ken Cook Co.
10 - 22
l Pontoon/Deck Boats
CORROSION PROTECTION
HARDWARE, FASTENERS AND FITTINGS
Check all fasteners, fittings, hinges, latches, rails and cleats for corrosion and
tightness. Repair or replace any items that need attention. Never use automotive
replacement parts when replacing marine parts.
Periodically clean all hardware with approved marine cleaners or mild soap and
water. Never use abrasive cleaners or materials; they will scratch the polish and
protective coatings on the hardware and cause the hardware to corrode. Applying a
coating of marine-grade wax can help maintain the original shine of the hardware
and help prevent corrosion.
STAINLESS STEEL AND CHROME HARDWARE
Stainless steel and chrome will normally oxidize over time, especially in marine
environments. Cleaning and preventive maintenance of stainless steel and chrome
hardware are crucial in maintaining appearance and functionality. If the hardware is
left unattended, it can corrode, causing the hardware to appear unsightly and
cause structural integrity problems.
Wash the stainless steel and chrome hardware with mild soap and water after
operating the boat in corrosive environments such as salt water.
KC-0158-A
INSPECT
HARDWARE
INSPECT
HARDWARE
STEERING
BAR
TYPICAL MECHANICAL
OUTBOARD ENGINE STEERING LINK
Copyright 2003 - 2020
© 2020 Ken Cook Co.
All Rights Reserved
www.KenCook.com/marine
To Next Page
Loading...