EasyManua.ls Logo

beno+ Reevo - Page 32

beno+ Reevo
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Under no circumstances, including, but not
limited to negligence, shall Beno or any Beno
distributor (seller) be liable for any damages,
including but not limited to special or
consequential damages that result from the
use of, or the inability to use, the Reevo bike
and/or any other products or materials
referred to in this manual, even if Beno has
been advised of the possibility of such
damages.
Applicable law may not allow the limitation or
exclusion of liability or incidental or
consequential damages, so the above
limitation or exclusion may not apply to you.
FCC Statement
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and
receiver.
•Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician
for help.
The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable
exposure condition without restriction.