40 How to choose the right Refresh Rate
How to choose the right Refresh Rate
You don't have to choose the highest possible refresh rate on an LCD display, because it is not technically possible for
an LCD display to flicker. The best results are obtained by using the factory modes already set in your computer.
There is a table with the factory modes in this user's guide. Youc an choose 60, 70 and 75 Hertz, (but not 72Hz) for the
native resolution of 1024 x 768. In Windows 95/98/2000/ME/XP you can change the refresh rate as follows:
1. Double click the “Display” icon in the Control Panel.
2. From the “Display Properties” window, select the “Settings” tab. Click the “Advanced...” button in
the bottom right corner.
6
To Next Page
Loading...
Need help?
General
