The OSD (On-Screen Display) menu 37
PAP Setting
(Continued)
• Picture Position: (PIP only) Changes the position of the sub picture.
• PAP is not available for all signal source combinations. See Supported PAP input signal
combination on page 65 for more information on supported combinations.
• In PAP mode, only sound from the active picture will be available.
Aspect
Sets the picture’s aspect ratio.
• Wide Zoom: Enlarges to fill screen with minimum distortion.
• Zoom: Enlarges the picture, keeping the same aspect ratio.
• Full: Enlarges the picture horizontally to fill the screen when the picture
source is 4:3 (Standard definition). When the picture source is 16:9 (High
definition), it displays in the same 16:9 aspect ratio.
• 4:3: Displays all picture source in 4:3 aspect ratio.
• Full 1: Enlarges the picture to fill the screen in the vertical direction,
keeping the same aspect ratio. A black frame may appear around the
picture.
• Full 2: Enlarges the picture to fill the screen.
• Real: Displays the picture in its original number of dots.
Upper Left Upper Right
Lower Left Lower Right
For video signal inputs
4:3 original source 16:9 original source
Wide Zoom Wide Zoom
Zoom Zoom
To Next Page
Loading...