Bentley R Type - Page 82

?8
THE
'R'
Tvpr BBNrtBv.
(vii) If
z
weights together are too much,
try
moving
them away
from
each other.
Go
one
hole
at a time and move each
weight alternately.
When
balance
has been achieved
add
the
z
weights opposite each other.
(viii) If
z
weights together are insufficient,
add a
third,
using
an adjacent
hole.
If this balances
the wheel,
remove the
centre
weight and refit it
4
holes to one side. Fit
the
4th
weight
4
holes to the
other side.
(i") If
3
weights are insufficient,
add the
4th,
and if this is too
much, start separating
the outer
z
weights as in (vi) above.
(")
Remove
the
wheel and reverse the
bolts so as to return
the
balance
weights
to their correct
position, on the inside of
the wheel.
("i) Refit
the wheel and
the
wheel
disc
assembly.
The
correct
tension
on
the disc is attained by
giving
the
nut one com-
plete
turn, with
the
special
spanner
provided, after
the disc
has
been felt
to
be
in contact with the
rubber stops on
the
wheel centre.