To Next PageTo Next PageWhat to do if Bently Nevada Control Unit monitor is not configured?
If the Bently Nevada Control Unit monitor is not configured, is in Configuration Mode, or in Calibration Mode, you should reconfigure the Monitor, or exit Configuration, or Calibration Mode. Also, check the System Event List for severity.
General| Model | 3500/42 |
|---|---|
| Category | Control Unit |
| Input Channels | 1 |
| Channels | 1 |
| Output | 4-20 mA |
| Alarm Relays | 2 |
| OK Relay | 1 |
| Output Signal | 4-20 mA |
| Housing Material | Aluminum |
| Operating Temperature | -40 to 85 °C |
| Storage Temperature | -40 to 85 °C |
| Module Type | Proximity |
| Input | Proximity sensors |
| Input Voltage Range | 18-30 VDC |
| Frequency Response | 0-10 kHz |
| Connector Type | Terminal Block |
| Communication Protocol | API |
When used in a TMR configuration, 3500/42 monitors and Proximitor/Seismic TMR I/O Modules must be installed adjacent to each other in groups of three.
This section shows the configuration screens of the Rack Configuration Software that are associated with the monitor and discusses the configuration considerations.
The I/O jumper on the Proximitor/Seismic I/O Module is used to identify the type of transducer connected to the I/O module.
The 3500 Monitoring System is a high precision instrument that requires no calibration. The functions of monitor channels, however, must be verified at regular intervals.
This section shows how to adjust the transducer scale factor and the transducer position, or "zero".
This section describes how to troubleshoot a problem with the Proximitor/Seismic Monitor or the I/O module by using the information provided by the self-test, the LED’s, the System Event List, and the Alarm Event List.
