Beper 2000W - Cleaning and Maintenance

8
Hair Kit Use instructions
STRAIGHTENER
TO STRAIGHTEN YOUR HAIR
• Separate your hair into sections. Clip the upper sections to the top of your head so that you can
work with the sections underneath.
• Take up a section about 2 to 3cm wide and place it between the 2 heating plates, near the roots
of your hair.
• Press the straightener handles, hold rmly to keep the section and slide the unit slowly down the
section from roots to tips.
• Take up a new section and continue in this way until all your hair is straightened.
• Repeat if necessary, then release the straighteners.
• Complete the style with a nishing touch. You may wish to set the straightening using a light misting
of hairspray.
HAIR DRYER
Fully unwind the cable
With the air speed selector, you can set the power of the airow as needed.
Settings.
0: turned off
1: medium airow, for a delicate drying of the ne and slightly wet hair.
2: stronger airow, for a faster drying
With temperature selector it is possible to set the airow temperature.
1: low temperature
2: medium temperature
3: high temperature
Cold air button
Allow to x the hairstyle without desiccating hair. Pressing this button, the cold airow button will
stop.
CONCENTRATOR
With the concentrator, the airow works on accurate areas, to get easily the desired hai rstyle.
This accessories allow to concentrate directly the airow on the locks, for an easy hai rstyle. Put the
concentrator on the hair.
CLEANING AND MAINTENANCE
• Unplug the unit and allow it to cool completely.
• Clean the plates using a soft, damp cloth, without detergent, to preserve the optimal quality of the
units. Do not scratch the plates