Beper P202ASP250 - Product Description and Operation; Assembly; Instructions for Use; Cleaning the Appliance

Ash Vacuum Cleaner Use Instructions
9
EN
Product description Fig. A
1. Handle
2. Blowing function connector
3. Engine
4. Closing hooks
5. Steel tank
6. Rigid aluminum tube
7. Corrugated tube with metal inside
8. Suction connector for the hose
9. Lid
10. Power button 0/I
11. Hepa lter
Assembly
Disconnect the plug from the socket when removing the various accessories. When using the appliance for
the rst time, remove all parts or components from the packaging and proceed with assembly.
Insert the aluminum lance into the connector connected to the corrugated pipe.
Insert the metal tube into the suction connector by turning it clockwise.
Instructions for Use
After carefully assembling the product, insert the plug into the socket, checking that the plug has not been
damaged.
Press the 0/I power key to turn the product on or off.
To activate the blower function, insert the metal tube into the connector located on the lid of the product, near
the handle and press the 0/I power button.
Warning: if abnormal noises are heard, switch off the product immediately.
Cleaning the appliance
It is important to keep the lters clean to improve the efciency and life of the product itself.
Make sure that the product is switched off (the power button must be positioned on 0) and disconnect the plug
from the socket before carrying out any cleaning and maintenance operation.
Disconnect the hose by turning it counterclockwise, open the locking hooks, remove the lid, and remove the
lter by pulling it away from the lid.
Empty the tank and, if necessary, wash it with water.
Drain the pipes and, if necessary, ush them with water.
After each use, shake the lters and remove the dust residues with a brush.
After several uses, if the suction power is reduced, wash the lters with plenty of running water from inside
the lter outwards, then leave them to dry completely for at least 24 hours, in the open air and in the shade,
before reassembling them (do not use dryers or other means) (Fig.B).
Washing in water gradually deteriorates the lters. If, after washing them, the suction power is still reduced,
replace the lters.
Reassemble the parts on the appliance only if they are completely dry.
The exterior of the product can be cleaned with a soft cloth slightly moistened with warm water.
Do not clean with thinners, abrasive products in general, detergents for plastic, glass or the like.
Be careful not to get any liquids inside.
Technical data
Power: 800W
Power supply: 220-240V~, 50-60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.