CIAO AT
60
g. 7
0
50
00
50
00
50
00
50
00
50
00
50
00
0 100 200 300 40 0 500 600 7 0 0 800 900 1000 11 00 1 200 130 0
Portata impianto [l/h]
Prevalenza res. disponibile all'impianto caldaie con recuperatore fumi
Circolatori codd. 20092011 - 20090619 - 20090620
[EN]
A System ow rate (l/h) / B Discharge head (mbar)
The residual discharge head for the heating system in terms of ow rate is
shown in the graph below.
The heating system pipes must be dimensioned according to the residual
discharge head available.
Note that the boiler is working properly if the heat exchanger for heat-
ing has sufcient water circulation. For this reason, the boiler is tted
with an automatic bypass that sets the correct ow rate for the water
in the heat exchanger.
CURVES WITH STANDARD CIRCULATOR
COURBES CIRCULATEUR DE SÉRIE
CURVAS DO CIRCULADOR DE SÉRIE
CURBE CIRCULATOR ÎN SERIE
CURVES WITH HIGH HEAD CIRCULATOR KIT
COURBES KIT CIRCULATEUR HAUTEUR MANOMÉTRIQUE ÉLEVÉE
CURVAS DO KIT DO CIRCULADOR DE ALTA PREVALÊNCIA
CURBE KIT CIRCULATOR DE ÎNALTĂ PREVALENŢĂ
0
50
100
150
200
250
300
350
400
450
500
550
600
650
700
0 100 2 00 300 4 00 500 6 0 0 700 800 9 00 1 000 11 00 120 0 1300 1400
Prevalenza [mbar]
Portata impianto [l/h]
Prevalenza res. disponibile all'impianto caldaie con recuperatore fumi
Circolatori codd. .............................
-
AA
BB
[FR]
A Débit de l’installation (l/h) / B Hauteur manométrique (mbar)
La hauteur manométrique résiduelle pour l’installation de chauffage est re-
présentée, en fonction du débit, par le graphique ci-dessous. Le dimension-
nement des tuyaux de l’installation de chauffage doit être effectué en tenant
compte de la valeur de la hauteur manométrique résiduelle disponible.
Il faut tenir compte du fait que la chaudière marche correctement si
dans l’échangeur du chauffage il y a une circulation d’eau sufsante.
Dans ce but, la chaudière est dotée d’un by-pass automatique qui
règle un débit d’eau correct dans l’échangeur.
[PT]
A Caudal de instalação (l/h) / B Prevalência (mbar)
A prevalência residual para a instalação de aquecimento é representada,
em função do caudal, pelo gráco mostrado abaixo.
O dimensionamento das tubagens da instalação de aquecimento deve ser
realizado tendo-se em mente o valor da prevalência residual disponível.
Recorde-se que a caldeira funciona corretamente se no permutador
do aquecimento tem-se uma circulação de água suciente. Para esse
m, a caldeira é dotada de um desvio automático que realiza a regu-
lação de um correto caudal de água no permutador.
[RO]
A Capacitate instalaţie (l/h) / B Prevalenţă (mbar)
Prevalenţa reziduală pentru instalaţia de încălzire este reprezentată, în
funcţie de debit, în gracul de mai jos.
Dimensionarea conductelor instalaţiei de încălzire trebuie să aibă loc ţinând
cont de valoarea prevalenţei reziduale disponibile.
Trebuie să se aibă în vedere că centrala funcţionează corect dacă
în schimbătorul de încălzire există o circulaţie sucientă a apei. În
acest scop, centrala este echipată cu by-pass automat care reglează
în mod corect debitul de apă în schimbător.