To Next PageTo Next Page
Need help?Do you have a question about the Beretta Junior Green C.S.I. and is the answer not in the manual?
General warnings and safety precautions for boiler installation and use.
Overview of the Junior Green C.S.I. wall-mounted condensing boiler.
Guidelines and procedures for installing the boiler.
Rules and procedures for proper boiler installation.
Guidance on selecting the optimal installation location for the boiler.
Required clearances for boiler installation and maintenance.
Procedure for cleaning the heating system and water properties.
Instructions for wall mounting and connecting hydraulic components.
Procedure for installing and connecting the external temperature sensor.
Steps for mounting and wiring the external sensor.
Detailed instructions for physically attaching the external sensor.
Guidelines for proper condensate drainage and prevention of freezing.
Procedures and checks for connecting the boiler to the gas supply.
Instructions for electrical connections and safety precautions.
Steps for filling the heating system with water.
Instructions for safely draining the heating system.
Procedure for emptying the domestic hot water system.
Steps to remove air from the heating system and boiler.
Regulations and methods for flue gas discharge and air intake.
Diagrams showing various flue gas discharge configurations.
Installation specifics for forced open configurations.
Installation specifics for sealed configurations.
Details on using twin pipes for flue gas discharge.
Step-by-step guide to powering on and starting the boiler.
Operation mode for heating and domestic hot water.
How to adjust the boiler's heating water temperature.
Operation mode for domestic hot water only.
Enabling the pre-heating function for faster hot water.
How to set the desired domestic hot water temperature.
Using the automatic temperature control system for efficiency.
Procedure to reset the boiler's operation.
Instructions for temporarily and long-term switching off the boiler.
How to switch off the boiler for short periods.
Interpreting LED indicators and fault codes on the control panel.
How to configure boiler settings using jumpers.
Adjusting thermoregulation settings using graphs and trimmers.
Procedures for adjusting boiler parameters.
Procedure for calibrating the gas valve for optimal performance.
Steps for converting the boiler between different gas types.
Procedure for analyzing and checking combustion parameters.
General