How to fix a gas smell in my Beretta Heating System?
If you smell gas coming from your Beretta Heating System, it could be related to the gas supply circuit. Check the seal of the gaskets and the closure of the pressure tapping points.
Why is my Beretta Boiler modular system becoming dirty very quickly?
If the modular system is getting dirty quickly, it could be due to the combustion process. Check the combustion controls.
Why does my Beretta Boiler have irregular combustion?
Irregular combustion can stem from several causes: burner gas pressure, so check the temperature setting; a diaphragm installed, so check the diameter; the burner and exchanger conditions, so clean the burner and exchanger; exchanger passages obstructed, so check passage cleaning; or a faulty fan, so check operation.
Why does my Beretta Boiler have odour of unburnt gas?
If you notice an odor of unburnt gas, it could be related to the flue gas circuit. Check the gasket seals, make sure there are no obstructions, and check the combustion quality.
Why is my Beretta Boiler generator triggering a thermal safety block?
The generator might be triggering a thermal safety block because there is no water. Check the correct functioning, the temperature setting, the electrical wiring, and the position of the sensor bulbs. Also, check the bleed valve and the heating circuit pressure, as the modular system adjustment may be the cause.
Why are there ignition delays with pulsations to the burner in the Beretta Heating System?
If the Beretta Heating System has ignition delays with pulsations to the burner, it could be due to the burner gas pressure or the ignition electrode. Check the setting of the burner gas pressure and the positioning and conditions of the ignition electrode.
What to do if the Beretta Heating System circulator does not start?
If the Beretta Heating System circulator does not start, it is possible that the pump is malfunctioning. You should check or unseize the pump, replace the circulator if necessary, and check the electrical connection of the circulator.
What to do if the Beretta Heating System burner does not start upon consent of the modular system control?
If the Beretta Heating System burner does not start upon consent of the modular system control, the gas valve may be the cause. Check for the presence of 230Vac voltage on the gas valve terminals and inspect the wiring and connections.
Why does my Beretta Boiler have ignition delays with pulsations to the burner?
If you're experiencing ignition delays with pulsations to the burner, it could be due to the burner gas pressure. Check the temperature setting. It could also be related to the ignition electrode, so check its positioning and condition.
What to do if my Beretta Boiler burner does not start upon consent of the modular system control?
If the burner isn't starting when the modular system control signals it to, the issue might be with the gas valve. Check for the presence of 230Vac voltage on the gas valve terminals and inspect the wiring and connections.
General| Category | Heating System |
|---|---|
| Type | Condensing Boiler |
| Heat Output (kW) | 50 |
| Fuel Type | Natural Gas/LPG |
| Efficiency | Up to 98% |
To Next Page
