Berker RolloTec 2930 - User Manual

RolloTec
RolloTec cutoff relay with/without extension unit outgo
ing
feeders
Page 1/7
10/2023
RolloTec cutoff relay
Order no.: 2930
RolloTec cutoff relay RMD
Order no.: 2931
RolloTec cutoff relay with extension unit outgoing feeders
Order no.: 2969
RolloTec cutoff relay with extension unit outgoing feeders RMD
Order no.: 2919
Operation and Assembly instructions
1 Safety instructions
Electrical equipment must only be installed and assembled by qualified electricians.
Always follow the relevant accident prevention regulations.
Failure to comply with these instructions may result in damage to the device, fire or other
hazards.
Disconnect before working on the device or load. Take into account all circuit breakers
that supply dangerous voltages to the device or load.
Use the device only for controlling Venetian blind, roller shutter or awning drives with
electronic or mechanical limit switches. Do not switch any other loads.
Secure blinds/shutters against unauthorised and unintentional operation. There must not
be any persons or objects in the movement range of the blinds/shutters.
These operating instructions are an integral component of the product, and must be
retained by the end user.
2 Structure of the device
Figure 1
Terminals
(1) Motor M1 and M2
Motor Up
Motor Down

Summary

Operation and Assembly Instructions

Safety Instructions

Electrical equipment must be installed by qualified electricians following safety regulations.

Structure of the Device

Describes the physical components and terminals of the RolloTec cutoff relay.

Terminals

Details the connections for motor, master control, power supply, and extensions.

Function

Explains the intended use and operation of the RolloTec cutoff relay.

Intended Use

The RolloTec cutoff relay is used for electrical decoupling of two conventional motor drives.

Product Features

Highlights key features such as control of two drives, separate power, master control input, and group circuits.

Master Control

Explains how drives are moved simultaneously using a master command from a signal generator.

Single Control

Describes the possibility of separate operation of drives for units with extension feeders.

Information for Electricians

Provides essential information and warnings for qualified electricians during installation.

Assembly and Electrical Connections

Details the assembly process and electrical connection requirements, including safety warnings.

Appendix

Technical Data

Lists technical specifications such as voltage, current, dimensions, and connection types.

Troubleshooting

Offers solutions for common issues like blinds moving incorrectly or not moving at all.

Warranty

Outlines the warranty terms and conditions for the product.

Address of Manufacturer

Provides the contact details and address of the manufacturer, Berker GmbH & Co. KG.

Berker RolloTec 2930 Specifications

General

Brand	Berker
Model	RolloTec 2930
Category	Relays
Language	English