What to do if the power cord is damaged on my Berkshire Blanket heated throw Accessories?
If the power cord or wiring of your Berkshire Blanket Accessories is damaged, stop using the product immediately. Contact customer care at 800-372-2018 or customercare@berkshireblanket.com for assistance.
Why is the standby light flashing on my Berkshire Blanket heated throw control unit?
If the standby light on your Berkshire Blanket Accessories control unit is flashing, ensure the female connector is fully pushed in. If the issue persists, switch off the control unit at the back, then switch it back on. If it continues to flash, this indicates a fault.
How to fix light that is not illuminating on my Berkshire Blanket heated throw Accessories control unit?
If the light on the control unit of your Berkshire Blanket Accessories isn't illuminating, first ensure the switch is properly attached and that you've followed the instructions correctly. Also, verify that the power supply is working and that the control unit is switched 'ON'.
Connect control unit to throw, run cord, and plug into wall outlet.
How to turn on, select heat, use preheat, and auto-off.
Understanding the auto-off feature and recommended disconnection.
Steps before cleaning/storing: disconnect, check wires, follow label.
Detailed steps for machine washing the heated throw.
Instructions for machine drying and air drying the throw.
Proper methods for storing the throw to prevent damage.
Solutions for common problems like non-illuminating lights or damaged cords.
General| Brand | Berkshire Blanket |
|---|---|
| Model | heated throw |
| Category | Accessories |
| Language | English |
To Next Page