Top Assembly Detail
Control Panel Installation
Hardware Included
Tools / Items Needed
3/4" Panhead Screws
(x4)
Assembly Guide
DRFT4254C
Donoma 42"x 54" Rectangular Fire Table
(Dining, Counter & Bar Heights)
Cordless Drill
#2 Square Drive Bit
+
DRFP4254
Donoma 42"x 54" Rectangular Fire Pit
Allen Wrench
(included)
1 - AAA Battery
(not included)
Cresent Wrench
7/16" Wrench
1/4" x 2 1/2" Bolts
(x4)
1/4" Flange Nuts
(x4)
Fasten the Fire Pit Top to the Fire Pit
Base by inserting four 1/4" x 2 1/2"
bolts through the rectangular slots.
The bolt heads should be on the
outside of the base.
Fasten on the inside of the base
using the 1/4" Flange Nuts.
Locations of Slots for Bolts
Step 1
Step 2
Place the control panel into the cutout located in
one of the long sides of the fire pit base.
Fasten it using four 3/4" Panhead Screws.
Applies for: DRFP4254, DRFT4254D, DRFT4254C, DRFT4254B
Need help?
General
To Next Page
