English | 15
1 619 929 L30 • 31.7.12
Maintenance and Cleaning
f For safe and proper working, always keep the
machine and ventilation slots clean.
After-sales Service and Cus-
tomer Assistance
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Berner power tools.
In all correspondence and spare parts orders, please
always include the 6-digit order number given on the
nameplate of the machine.
Accessories
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must be
collected separately and disposed of
in an environmentally correct manner.
Subject to change without notice.
Changing the chisel position
(Vario-Lock)
8 159
Changing the position of the
auxiliary handle
9 160
Adjusting the drilling depth X 10 160
Switching on and off and set-
ting the speed
11 161
Locking-on the On/Off switch 12 161
Releasing the On/Off switch 13 161
Action Figure Please observe Page
X
Article number
Keyless Chuck 13 mm 34115
SDS-plus quick change chuck 34114
To Next Page
Loading...
