Bernina bernette 0 - Page 108

EN
104
10 12 15
- Turn stitch length dial to the desired length.
- Pattern selector dial on " " or " ".
- Turn zig-zag width dial to small width.
(model 15)
- Cut out the applique design and baste it to
the fabric.
- Sew slowly around the edge of the design.
- Trim excess material outside the stitching.
Make sure not to cut any stitches.
- Remove the basting thread.
- Tie top and bottom thread under the
applique to avoid unraveling.
Please note:
No "S" marking is shown on the stitch length
dial by model 10.
Applique