EN
92
10 12
Presser foot available as optional accessory.
Set the machine as illustrated.
Install the darning plate. (1)
Remove the presser foot holder. (2) (see
page 26)
Pattern selector on " " or " ".
Turn the stitch length dial to "0".
Attach the darning foot to the presser foot
bar. The lever (A) should be behind the
needle clamp screw (B). Press the darning
foot rmly from behind with your index nger
and tighten the screw (C). (3)
First sew round the edge of the hole (to
secure the threads). (4) First row: Always
work from left to right. Turn work by 1/4 and
oversew.
A darning ring is recommended for easier
sewing and better results.
Remove darning plate for normal use.
Please note:
No "S" marking is shown on the stitch length
dial by model 10.
Free motion darning
To Next Page
Loading...
