Bernina bernette 2 - Twin Needle Sewing

EN
106
10 12 15
- Turn stitch length dial to the desired stitch
length.
- Pattern selector on " " or " ".
- Center needle position.
- Make sure that the two threads used to
thread the twin needle are of the same
weight. You can use one or two colors.
- Insert the twin needle in the same way as
single needle. Flat side of needle should
face away from you.
- Follow instructions for single needle
threading. Thread each needle separately.
Please note:
When sewing with twin needle, always
proceed slowly, and make sure to maintain
low speed to insure quality stitching. When
using twin needle on zigzag makesure the
stitch width dial is set between "0" and "2.5".
Do not use twin needle atsetting above
"2.5". (model 15 )
Use only twin needle assemblies with max.
2 mm needle distance.
(i.e.bernette part number 502020.62.91)
Please note:
No "S" marking is shown on the stitch length
dial by model 10.
Twin needle