Bernina bernette 2 - Connecting Machine to Power Source

EN
22
10 12 15
Connect the machine to a power source as
illustrated.
Attention:
Unplug power cord when machine is not in use.
Sewing light
Press main switch for power and light on. (1)
Position 0 - Machine is switched off.
Position I - Machine and sewing light is
switched on.
Foot control
Foot control regulates the sewing speed. (2)
Attention:
Consult a qualied electrician if in doubt as
to connect machine to power source. Unplug
power cord when machine is not in use. The
appliance must be used with the foot controller
KD-1902 (100-120V area) / KD-2902 (220-240V
area) manufactured by ZHEJIANG FOUNDER
MOTOR CORPORATION Ltd. (China).
IMPORTANT NOTICE
If the appliance has a polarized plug (one blade
is wider than the other). To reduce the risk of
electric shock, this plug will t in a polarized
outlet only one way. If the plug does not t fully
in the outlet, reverse the plug. If it still does not
t, contact a qualied electrician. Do not modify
the plug in any way.
The optimal operation temperature for the
failure-free operation of this machine must be
68°F +/- 50°F.
Connecting machine to
power source