Bernina bernette 2 - Adjusting Pattern Balance; Adjusting Stretch Stitch Patterns; Adjusting Buttonhole Stitch Density

EN
48
15
If the decorative stitch patterns or
buttonhole are uneven when sewing with
particular fabrics, turn the feed balancing
dial* with a screwdriver for adjustment.
* This dial should usually be in a neutral
position. (1)
Adjusting distorted stretch stitch
patterns
If the patterns are too open, turn the dial
counterclockwise. (2) "-"
If the patterns are too close, turn the dial
clockwise. (2) "+"
Adjusting the stitch density of
buttonhole
If the stitches on the right side of the
buttonhole are too open, turn the dial
counterclockwise. (3) "-"
If the stitches on the right side of the
buttonhole are too close, turn the dial
clockwise. (3) "+"
Adjust pattern balance