11. Inspecting the brakes.
Inspect and clean the brakes as-
sembly regularly in line with the
operating conditions, according to
the following instructions:
1) Unscrew the 3 screws (A) faste-
ning down the inspection cover (B)
using a box spanner.
2) With the help of a rubber hose,
run water into the 3 slots (C) until
you see clean water run out .
3) Replace the inspection cover
(A).
AIRBORNE NOISE
EC Certicate of Conformity
HANDLEBAR VIBRATION
Statistically weighed measurement
in accordance with
EN 1033: 13.3 m/s2
Data refers to maximum values
recorded with the range of engines
available.
To Next Page
Loading...
