Why is the control valve leaking from port D on my Bestway Swimming Pool Filter?
If the control valve on your Bestway Swimming Pool Filter is leaking from port D, it could be because the control valve is set between two functions; ensure it is set to only one function. Alternatively, the gasket may be broken, in which case you should replace it.
What to do if the connectors leak on my Bestway Swimming Pool Filter?
If the connectors on your Bestway Swimming Pool Filter are leaking, it might be due to a few reasons. Check if the washer of the connectors is not in place and reposition it. If the washer is broken, replace it. Also, ensure that the hoses are not loose and tighten them if necessary.
Why is sand flowing to the pool from my Bestway Flowclear 58336E Swimming Pool Filter?
If sand is flowing into your pool from the Bestway Swimming Pool Filter, here's what might be happening: * The sand might be too fine. It's recommended to use 0.45 mm (0.02 in) to 0.85 mm (0.03 in) #20 silica sand. * The sand level could be too high. Make sure the sand level is between the 'MAX' and 'MIN' markings on the hub. * The skimmer might be broken. If so, replace it.
General| Shape | Round |
|---|---|
| Material | PVC |
| Installation Time | 30 minutes |
| Type | Above Ground |
| Dimensions | 12 ft. x 30 in. (3.66 m x 76 cm) |
| Filter Pump | 530 GPH |
| Frame material | Metal |
| Best suited for pool height | 30 inches |
To Next Page