To Next PageTo Next PageWhy does my Bestway Water Pump display "Er" or the app say "Filter pump detects no water flow"?
This message appears when the system doesn't detect water flow. Ensure the pool's inlet and outlet are fully covered by water, and that the inlet and outlet valves are open. You may also need to purge air from the circulation system.
What to do if the Bestway FLOWCLEAR 58680 filter indicator lights up or the app prompts "Filter cartridge is dirty / Low flow rate"?
This can happen for several reasons. First, check that the control valve is open completely. Also, look for and remove any debris blocking the hoses or debris screen. Finally, the filter cartridge might be dirty; rinse it, and if the error persists, replace it with a new one.
How to fix a Bestway FLOWCLEAR 58680 Water Pump Wi-Fi setup that is not successful?
A failed Wi-Fi setup can occur due to several reasons: * If your router is dual-band, ensure the pump connects to the 2.4GHz network, as 5GHz is not supported. * Verify the pump is close enough to the router for a full Wi-Fi signal. * Double-check that you've entered the correct Network Name and Wi-Fi password. * Ensure the router works correctly and the Wi-Fi signal is stable. * Keep the pump and router away from other electronic devices that may cause interference. * Deactivate airplane mode on your mobile device during registration.
What to do if the Bestway FLOWCLEAR 58680 Water Pump app prompts "The filter pump is off and cannot be controlled"?
This alarm appears if the timing interface is open and the filter pump is switched off simultaneously. To resolve this, simply click 'x' to close the prompt.
General| Model | FLOWCLEAR 58680 |
|---|---|
| Pump type | Cartridge Filter Pump |
| Voltage | 220-240V |
| Hose diameter | 1.25 inches |
| Pump capacity | 2000 GPH |
| Filter Media | Sand |
| Filter cartridge type | Type I |
| Filter Type | Cartridge filter |
Instructions for securing the filter pump base before use, ensuring stability and safety.
Guidance on selecting an optimal placement for the pump relative to the pool.
Steps for connecting the filter pump to the pool's circulation system correctly.
Explanation of the different states and meanings of the Wi-Fi indicator LED on the pump.
