Scope of Presentation
• This presentation is intended for both experienced field personnel familiar with
warewashing installations, as well as new field service personnel who have
only a rudimentary knowledge of accessing triggers and conductivity control.
• The objective is to train the installer to be able to install a UniView control
dispenser on either a door or conveyor dishwashing machine, and troubleshoot
any unusual conditions they may encounter. To train new installers, we
recommend using this presentation in conjunction with an actual installation or
at least a lab installation followed by a site visits to see typical conveyor and
door machine installations.
• Excluded from this presentation is detailed training on electrical safety, which
should always be performed prior to attempting any high voltage installations.
In brief, however, power to the dishwasher and dispenser should be shut off at
the source prior to opening them, and a voltmeter should be used to verify the
power’s off prior to doing wiring.
To Next Page
Loading...