Beta D3000 - User Manual

Need help?

Do you have a question about the Beta D3000 and is the answer not in the manual?

Summary

Scope of Presentation

D-Series Feature Comparison

Mounting Location

TUBING: Chemical Pickup Lance Connection

TUBING: Pump Connection

TUBING: Injection Fittings

Solenoid & Bowl

WIRING: Trigger Connection

OPTIONAL WIRING: Low Level Alarm

WIRING: Probe Connection

Prime the Pumps

Potentiometer Programming

Uniview Programming

Programming: Mode Selection

Programming: Machine Type

Programming: Conductivity Reading

Programming: Conductivity Setpoint

Programming: Detergent Recharge

Programming: Initial Charge

Programming: Rinse Delay

Programming: Rinse Speed

Programming: Rinse Runtime Limit

Programming: Wash Tank Temperature Reading

Programming: Alarm Volume

Programming: Detergent Pump Speed

Programming: Sanitizer Signal & Alarm Logic

Programming: Sanitizer Speed

Programming: PCB ID Code

Programming: Rack Counts

Programming: Drain Count

Programming: Conductivity Range

Programming: Conductivity Reading without VCP Correction

Programming: Control Source

Programming: Firmware Version

Tank Titration: Step 1 =Check Water Hardness

Tank Titration: Step 2 = Titrate for setpoint & tank fill

Tank Titration:Step 2 = Titrate for recharge

Troubleshooting & FAQ

Probe Troubleshooting Chart

Properly Rated Fuse Blows Repeatedly

Programming Chart Reference

Patented Learning Algorithm Logic

Patented Learning Algorithm = Sales Tool

Probe Alarms

Low Detergent Alarm

Alerts operator to low detergent levels or open wash tank drain, sounding an alarm from the sixth feed.

Overfeed Stop Alarm

Unit stops operation after tenth feed; alarm becomes a continuous loud sound. Cannot be programmed while in this state.

UniView Communication Trouble