Beta D3000 - Programming: Initial Charge

• The initial charge is the amount of time
the detergent pump or solenoid will be on
when filling an empty tank.
• This initial charge will occur 20 seconds
after the power is applied and after the
normal recharge. Its purpose is to get the
wash tank concentration up quickly. For
single-tank, probeless systems, input a
time between 0 and 240 seconds. Use the
DATA UP and DATA DOWN keys to input
the initial charge time, then press SEND.
• The example displays an initial charge
time of 60 seconds. The default is 30.
For probeless dump and fill
systems, input a 0 (initial
charge is not used).
Programming: Initial Charge
Probeless mode only