Once you’ve determined the number of seconds to run the initial charge, and
the tank is titrated to the correct concentration, you can titrate for the
recharge amount:
4. Turn dispenser off, and run a rack through the dishmachine.
5. Once again, use a stopwatch and press the prime button for a couple
seconds to allow detergent to feed, and retitrate until you know the correct
number of seconds to restore the correct detergent concentration to the tank.
Use this number of seconds in UniView menu 4 detergent recharge.
Tank Titration:Step 2 = Titrate for
recharge
Probeless mode only
To Next Page
Loading...