Beurer BC 54 User Manual

18
Error
message
Possible
cause
Solution
The cu was
not attached
correctly.
Please observe the notes
in chapter "7. Usage"
under the section "Atta-
ching the cu".
During a new measure-
ment, check whether the
cu can now be inflated
properly.
4
An error oc-
curred during
measurement.
Please wait one minute
and repeat the measu-
rement.
Ensure that you do not
speak or move during
the measurement.
4
The inflation
pressure is
higher than
300 mmHg or
the measured
blood pressure
is outside the
measuring
range.
4
The batteries
are almost
empty.
Insert new batteries into
the device.
Error
message
Possible
cause
Solution
7
The data could
not be sent via
Bluetooth
®
.
Proceed as described in
chapter „7. Usage“ under
the section
„Transfer via Blue-
tooth
®
“ into the manual
memory mode and try to
restart the data transfer.
8
A device error
has occurred.
Please repeat the mea-
surement after a pause
of one minute.
If the problems persist despite the proposed corrective
actions, please contact customer service.
10. Disposal
Repairing and disposing of the device
• Do not repair or adjust the device yourself. Proper op-
eration can no longer be guaranteed in this case.
• Do not open the device. Failure to comply will result in
voiding of the warranty.
• Repairs must only be carried out by Customer Services
or authorised suppliers. Before making a claim, please
check the batteries first and replace them if necessary.

Beurer BC 54 Specifications

General

Type	Automatic
Cuff size	13.5 - 21.5 cm
Control type	Buttons
Memory slots	2
Certification	CE
Compatibility	iOs 10.0, Android 5.0
Product color	Black
Speaking function	No
Placement supported	Wrist
Pulse rate measuring	Yes
Battery type	AAA
Battery voltage	1.5 V
Display type	-
Package depth	124 mm
Package width	96 mm
Package height	109 mm
Package weight	381.8 g

Weight and Dimensions

Depth	80 mm
Width	69 mm
Height	68 mm
Weight	220 g