Beurer HT 60 - Core Operation and Settings; Changing Styling Attachments

16
Notes
• Remove all packaging material before using the device.
• Connect the device only to a socket featuring the voltage stated on the type plate.
• Only pull the mains cable from the socket by the mains plug.
•
Do not use any additional parts that are not recommended by the manufacturer or oered as accessories.
• Under no circumstances should you open or repair the device yourself, as faultless functionality can no
longer be guaranteed thereafter. Failure to comply will result in voiding of the warranty.
• In the event of a fault or damage, have the device repaired by a certified specialist workshop.
• Never leave the device unattended during use.
• Do not use the device outside.
• If you pass on the device to someone else, make sure to also pass on these instructions for use.
6. Operation
Warning
• Position yourself on a dry, non-conductive surface. Risk of electric shock!
• Make sure that your hands are dry! Risk of electric shock!
• Your hair must be dry! Risk of electric shock!
• The device can become very hot. When the device is hot, it must only be held using the handle [6] – risk
of burns and fire!
• Do not touch the hot plates [1]. Risk of burns!
• Do not wedge any objects between the hot plates [1] and the heating tube and the clip piece.
• Switch the device o immediately if it is faulty or not working properly.
• Place the multi-functional styler with the support stand [13] folded out on a stable, horizontal and
non-flammable surface, or hold the multi-functional styler in your hand. Risk of fire!
• Always allow the connected attachment to cool before removal – risk of burns!
Important
• Untangle the mains cable [9] if it is twisted.
• Do not pull, twist or bend the mains cable [9] and do not pull or route it over/on sharp, pointed objects or
hot surfaces.
• Do not trap the mains cable [9] in drawers, doors, between the hot plates [1], etc. Damaged or tangled
mains cables increase the risk of electric shock!
Changing attachments
> Select the appropriate attachment for the desired
hairstyle [12, A, B, C].
> Turn the locking ring [10] fully clockwise. The connected attach-
ment is released.
> Take the attachment o the handle [6].
> Align the selected attachment as shown in the image.
> Without tilting the two metal pins, carefully slide the selected
attachment into the handle [6].