20
Note
The wave styler features a safety switch-o function. After approx. 25 min-
utes, the LED temperature display starts to flash [6] to remind you about the
automatic switch-o. If you want to use the wave styler for longer than 30
minutes, switch the device o and then immediately on again. The safety
switch-o function is then reset to activate again in 30 minutes.
4.2 After use
1. To switch o the wave styler after use, hold down the ON/OFF button [5] for
three seconds. The heating rods [2] are now switched o and the LED temper-
ature display [6] goes out.
2.
Pull the mains plug [11] out of the socket after each use.
Do not wind the mains cable [10] around the device!
3. Place the wave styler on a stable, horizontal and non-flammable surface to cool
down. Make sure that the hot heating rods [2] do not touch the surface! Risk of fire!
4. Wait until the heating rods [2] of the wave styler have cooled down completely.
Then store the wave styler in a dry place out of the reach of children. Alterna-
tively, you can hang up the wave styler on a hook using the hanging eyelet [9].
5. CLEANING AND MAINTENANCE
Important
• Always pull the mains plug out of the socket before cleaning the device. Risk
of electric shock!
• Do not clean the wave styler with highly flammable liquids. Risk of fire!
Warning
• Ensure that no water gets inside the device! Risk of electric shock!
To Next Page
Loading...
