Beurer HT 80 - Blower and Temperature Settings

25
Step 2: Plugging the mains plug into the socket
> Insert the mains plug of the hot air brush into a suitable socket.
Step 3: Preparing your hair
> Dry your hair with a towel beforehand.
> Comb your hair thoroughly.
Only use the hot air brush on pre-dried, slightly damp and well-
brushed hair.
Step 4: Blower and temperature settings
Slide the sliding switch [6] on the hot air brush to the required blower
and temperature setting (2, 1 or
).
Setting Blower and tempera-
ture settings
Hair type/application
2
High blower setting, high
temperature
For thick hair
1
Gentle blower setting, me-
dium temperature
For fine hair
High, cold blower setting For finishing the hairstyle
Step 5: After use:
> After use, slide the sliding switch [6] to position 0.
> Place the hot air brush on a heat-resistant surface and allow to cool.
> Then clean the hot air brush as described in chapter "7. Cleaning".
> Store the hot air brush in a safe, cool and dry place. If you prefer, you
can hang up the hot air brush using the hanging eyelet [10].