27
> Hold this position for approximately 20 seconds.
> After the 20 seconds, slide the sliding switch [6] to the position to
fi nish the section.
> Use the rotation button to unwind the section completely in the op-
posite direction.
> Repeat steps 1 to 6 to curl the rest of your hair.
Round brushing inwards:
> Use the heated brush [2].
> If you have fi ne hair, slide the sliding switch [6]
to position 1.
> If you have thick hair, slide the sliding switch [6]
to position 2.
> Place the heated brush [2] under a section of
hair at the tips.
> Hold down the wind rotation button until the tips
curl in as required.
> Hold this position for approximately 20 seconds.
> After the 20 seconds, slide the sliding switch [6] to the position to
fi nish the section.
> Use the rotation buttons to unwind the section completely in the op-
posite direction.
> Repeat steps 1 to 6 to curl the rest of your hair.
Note
• If your hair becomes knotted while winding or unwinding, switch o the
device and carefully release the hair from the attachment.
7. Cleaning
Important
• Always pull the mains plug out of the socket before cleaning the device.
Risk of electric shock!
• Ensure that no water gets inside the device! Risk of electric shock!
To Next Page
Loading...
