EasyManua.ls Logo

Beurer LB 55 - Individual Part Cleaning; Pad Replacement; Descaling the Humidifier

Beurer LB 55
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
Clean individual parts
Wash the pad [4] with clean water. You can remove stubborn limescale by first putting the pad
[4] in a weak vinegar solution. If the pad [4] is hard and rigid, it must be replaced (see next secti
-
on 3 ‘Changing the pad’).
Clean the following individual parts of the appliance thoroughly with washing-up liquid and warm
water. Any residue from cleaning agents should be thoroughly removed.
Tank [8] and tank catch [9]. When cleaning the tank catch [9], do not damage the valve.
Steam tower [3] and steam nozzle [1].
Cover [2].
Changing the pad
Note
Pads are obtainable from the service address or from the authorised dealer.
Remove the worn pad [4] from the hotwater chamber. Dispose of the pad in the household
refuse.
If there is any water left in the appliance, pour it out.
Use a new pad [4].
Wash out the new pad [4] with clean water and put in the hotwater chamber.
Descaling the appliance
Descale the air humidifier
Note
Never try to remove any limescale deposit with pointed or sharp objects. This might damage the
air humidifier or cause it to leak.
Use either a citric acid solution (30 g pure citric acid powder dissolved in 1 l water) or a vinegar
solution (household vinegar with 5% acid content mixed with water in a ratio of 1:2) as a desca
-
ling solution.
Fill the hotwater chamber up to the brim with descaling solution.
Leave the descaling solution to work until the limescale has dissolved.
Pour away the descaling solution. Tip the appliance sideways to remove the descaling solution.
Rinse out the appliance thoroughly with clean water.
Repeat this procedure if necessary.
After cleaning and descaling
Insert the pad
Put the cleaned pad or replacement pad [4] into the hotwater chamber.
Assemble the appliance
Put the steam tower [3] back into the air humidifier. Press the steam nozzle [1] into the opening
at the top of the steam tower [3].
Screw the tank catch [9] onto the water tank [8]. Place the water tank [8] in the air humidifier.
Place the cover [2] on top of the air humidifier.

Table of Contents

Related product manuals