Need help?Do you have a question about the Bewator K44 Duo and is the answer not in the manual?
General| Brand | Bewator |
|---|---|
| Model | K44 Duo |
| Category | Door locks |
| Language | English |
Describes using two relay outputs to control two doors or functions with a single code.
Explains how to disable codes temporarily using time clocks for access control.
Details the conditions for activating the duress or alert output.
Explains how to use an external contact to enable/disable zero opening via the zero button.
Describes the toggle function to keep a door unlocked until a valid code is entered again.
Details the option to connect a door bell to the unit for visitor signaling.
Describes the keypad layout, including numeric keys, A/B buttons, and LED indicators (Red, Yellow, Green).
Explains the function of button A as a door bell and for initiating programming sequences.
Details the function of button B for entering the password and accessing programming mode.
Illustrates the wiring terminals for controlling two electric locks.
Shows the connection points for exit buttons or sensors and door contacts.
Depicts the power input terminals and connections for external LEDs.
Describes terminal functions for power, extra LED, and tamper switch.
Explains inputs for external time clock code disabling and door contacts.
Details output for alert/duress, door bell connection, and exit button functionality.
Introduces the programming process, guiding users with buzzer and LEDs.
Notes that the code lock returns to normal operation if no button is pressed within 20 seconds.
Details steps for setting or changing the device's 6-digit password.
Explains how to access programming mode with a password and how to exit it.
Guides on how to enter new access codes, specifying code location and length.
Clarifies code length rules and how to assign codes to relay outputs.
Explains how to configure codes to be disabled by time clocks.
Outlines the steps to erase existing codes, requiring the current code and confirmation.
Guides on how to change an existing code, including its value, time clock, and relay output.
Explains the process of entering the new code twice and selecting its associated settings.
Details how to set the duration the lock remains open after a valid code entry.
Provides instructions to turn off and reactivate the keypad's background lighting.
Guides on how to deactivate the buzzer for keypresses and door opening sounds.
Explains how to activate and deactivate the toggle function for permanent door unlocking.
Explains how a user can enter a special code under threat to activate an alarm output.
Details conditions for activating the alert output, such as door left open too long or forced open.
Allows selection between Door Alert (default) or Duress function.
Guides on how to activate door monitoring to trigger warnings if the door is open too long or forced.
Details how to set the duration for the door held warning time.
Allows selection of which relay output the new door held warning time applies to.
Explains how to activate and deactivate the delay function for sequential door opening.
Provides instructions to erase all programmed information, including the password, returning to factory settings.
Describes how to open the lock using a 4 or 6-digit code and how to release blockages.
Details the procedure to unlock and re-lock the door permanently.
Explains how to enter a modified code to activate the alarm output when forced.
Lists power supply voltage, consumption, and maximum load over relay contacts.
Provides physical dimensions, suitable mounting height, and optional mounting kit information.
To Next Page
