bewello BW2010 - Product Overview and Setup; Product Description; First Steps

EN
Air Cooler and Humidier
USER MANUAL
Product description
As summer approaches, we will do our best to have a pleasant, livable temperature in our home. With this on-wheel air cooler, you
can easily increase your comfort. Just ll the tank with cold water, add ice or put an ice pack in the tank and connect it to a wall
socket, and you can already enjoy the cool breeze. The device is also able to increase the humidity in the air to prevent unhealthy
low humidity.You do not need to get up from the chair to control the device, you can easily set the desired function with the help
of the included remote control.
• Instant cool airow • Quiet night mode
• Cools and humidies at the same time • Timer
• High capacity water tank • 3 blowing stages
• It can even be used with ice or ice pack • Included with remote and rell ice packs
• Easy to remove and clean lter insert • Oscillation function (horizontal)
• Manually adjustable vertical slats • Easy to move thanks to the wheels
Power supply: AC 220 - 240 V, ~ 50/60 Hz
Size: 590 x 215 x 245 mm
Material: Plastic
Airow: 350 m
3
/ hours
Tank size: 3.8 l
Power supply of remote: CR2025 - 3 V
Cable length: 120 cm
Color: White
Fan: Adjustable in 3 steps
airow strength (max 6.5 m/s)
First steps
Place the fan on a horizontal, stable, dry surface. Make sure that the appliance cannot roll. Fill the tank of appliance with water. (If
possible, use softened tap water or distilled water to avoid possible limescale formationThe mains plug of the appliance must only
be connected to a socket with a compatible voltage level. Connect the device and turn it on using the power button on the top.
Ice pack rell: The package includes 2 ice packs. Before rst use, the cap should be removed and lled with tap water. Make sure
that the icing crystals in the ice pack do not scatter. Ice packs may only be lled with water up to the „MAX” mark. N do not use
other liquids! After lling, tighten the cap rmly onto the ice pack bottle!
You can also use the appliance as a conventional fan: By pressing the power button on the top of the device, the fan
operates with low air ow. You can switch o the device by pressing the button again.
The „Speed” button on the top of the device allows you to switch between the 3 blow speed.
The device also has a pleasant cooling and humidifying function if the built-in tank is lled with cold water.
The water tank cannot be removed from the appliance! When lling, make sure that only water enters the tank and that the
water level is constantly monitored. Do not overll the tank! If required, you can insert ice or the supplied ice pack into the tank.
It is essential that there is a sucient amount of water in the tank for the cooling function of the appliance to function properly.