bewello BW2010 - Operation Modes and Safety; Device Modes Explained; General Safety Warnings; Electric Shock Prevention

Modes
Day: The device operates at maximum eciency. By default, it releases as much water vapor as possible into the air.
This provides a pleasant, cooling breeze.
Power saving: Adjusts the fan speed so that the device consumes less power.
Night: Quiet operation of the device. You can even sleep with the device on.
Timer: The timer button automatically shuts o the device after the set time. Hourly timing is possible, so the device can be
switched o in a wide range: between 1 and 12 hours. When using the timer and cooling function together, make sure that there
is enough water in the tank for that duration!
Oscillation: Press the (<->) button to start horizontal oscillation (slat movement). When the button is pressed again, the
movement of the slats stops at that position. The horizontal slats can be manually adjusted to the appropriate angle.
WARNINGS!
Do not add essential oil to the appliance or the water tank of the appliance!
General advice
Danger of suocation! Please keep the packaging of the appliance out of the reach of children as it may lead to suocation. The
appliance may only be used by adults, the storage location must be chosen so that children do not accidentally access it. Children
should be supervised to ensure that they do not play with the appliance.
The device may only be used for its intended purpose! When using, pay attention to the physical safety and safety of those around
you (especially children). The device may only be used by people who have read, understood and are able to operate this device in
accordance with the operating instructions! People with reduced mental, physical or sensory capabilities must not use the device!
Children should not use the appliance!
Do not use the device if you have previously dropped or struck it and it is visibly damaged! It is strictly forbidden to modify or
disable safety devices, use as intended!
Risk of electric shock
Never operate the appliance with wet, wet hands! Touching the device, including the power plug and cable, with wet hands is
strictly prohibited! The device may only be connected to AC power with the correct voltage. Only connect the appliance to a mains
socket that is safe to operate or has been installed by a specialist in accordance with IEC 60364-1. Do not point the device directly
at electrical equipment, as moisture may enter and damage them. In this situation, there is a risk of short circuit and electric
shock. Do not ll the appliance with water while it is connected to the mains! Do not use the appliance near a bathtub, shower,
swimming pool or sink containing water.
Before each use, make sure that the appliance and the mains cable and connectors are intact! Only undamaged devices may be
operated! If you experience any damage, do not use the appliance, contact a specialist! During use, pay attention to the integrity
of the power cord, avoid edges or objects that can damage the surface of the cord. Avoid the use of extension cords or splitters,
as they are a source of danger during operation. Use only splash-proof extension cords with a cross-section of at least 3 x 1 mm
2
.
Always unplug the appliance when not in use. Maintenance work must only be carried out with the mains plug removed.
Operation
Do not ll the tank with detergent! Use the appliance only above freezing temperature 0 °C to avoid condensation and electric
shock. Never leave the appliance unattended when it is connected to the mains! The device should only be used indoors, protected
from environmental factors. (IP20)
Always operate and store the device as described! Always check the integrity of the appliance, cable, plug and accessories! Do not
use the device in case of damage! Use the dehumidier only on a horizontal, stable surface! Be careful not to move or rotate the
appliance if there is water in the appliance, as this may lead to electrical damage or short circuits Be careful not to move or rotate
the appliance if there is water in the appliance, as this may lead to electrical damage or short circuits! If the unit is accidentally
moved or overturned, immediately disconnect the power supply (~ 230 V) and allow the unit to dry for at least 48 hours.