3
OPERATION
I.ALWAYS turn on your transmitter before you turn on the receiver in the vehicle.Always power
off the receiver before turning your transmitter off.
2.ALWAYS operate your vehicle in a wide open area.
Opeating the vehicle on slipery floor or indoors may
crash because Of the high speed.
3.WARNlNG: please be cautious that the water level
should be lower than the bottomof the truck. If
excessive amount of water gets into the body of the
truck and causedamageor other related problems,
we will not be responsible for such dama es.
customers will be responsible for any rep acements
and additional accessories if needed.
J waterV
4.ALWAYS start with low speed. or the vehicle may slip or run on curves. (as shown on Pic I ) NEVER
operate your vehicle in max speed. Operating the vehicle in highest speed may hurt yourself and
damage your vehicle.
a.Start
b. 15 km/h
c. 25km/h
MOTOR CARE
• Seat the motor brushes by driving smoothly on a flat surface during use Of the first battery charge.Failing to
do so can greatly reduce motor performance and functional life.
• Prolong motor life by preventing overheating conditions. Undue motor wear results from frequent turns.stops
and starts. pushing objects, driving in deep water and tall grass, and driving continuously up hill.
TROUBLESHOOTING
Problem
Short run time
Sluggish action
DO not operate
poor range
The system will not
Connect
The receiver uits responding
During opera ion
Receiver loses
Possible Cause
-Battery damaged/not charged
-Motor dirty or brushes worn
- Motor dirty or brushes wom
Bind in drivetrain
Vehicle battery is not charged
-Transmitter batteries low
-Transmitter powered off
- Vehicle battery is not charged
- Low transmitter batteries
- Receiver antenna damaged
- Transmitter and receiver too near each other
• Transmilter and receiver too near large metal
objects (vehicles. etc.)
- Receiver accidentally put in bind mode so receiver
is no longer bound
-Low battery voltage
- Transmitter accidentally put in bind
mode, ending bind to receiver
—3—
Solution
- Check/change battery
- Check/clean/replace
Check/clean/replace
- Clean/adjust
- Replace/recharge
Replace/recharge
Power On
Replace/recharge
- Replace/recharge
- Check/repair/replace
- Move transmitter 8-12 feet (2.4-3.6m)
from receiver
- Move away from large metal objects
(vehicles. etc,)
•Rebind transmitter and receiver
- Completely recharge battery
Bind transmitter to receiver
To Next Page
Loading...