BFT Clonix 2E User Manual

Programming Manual
http://www.remotecontrol-express.com - TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151
Programming of your new remote control:
1. Open the casing of your receiver.
2. On the receiver circuit board, press the SW1 button. Let it go. The Led light of the receiver
blinks.
3. Press both buttons on your new remote control (both superior buttons if your remote
control has 4 buttons) until the LED light of the receiver illuminates fixedly.
4. Press the first button on your new remote control until the LED light of the receiver blinks
again.
5. The Led light of the receiver turns off.
6. The first button of your new remote control is programmed.
7. Repeat this procedure to program the second button of your new remote control. Use this
time the SW2 button on the circuit board of the receiver.

BFT Clonix 2E Specifications

General

Brand	BFT
Model	Clonix 2E
Category	Receiver
Language	English