BFT DEIMOS BT A400 User Manual

A
CB
D
Ø 19.5 - PG 11
Ø 30 - PG 21
Ø 16 - PG 9
D813946 00903_01 11-01-18
PREPARE THE ELECTRICAL CONNECTION SYSTEM BETWEEN THE TRANSFORMER PANEL AND
THE DEIMOS BT A400/600, ACCORDING TO THE CABLE DATA INDICATED IN THE ATTACHED TABLE
CPEM WITH BT A400/A600 TRANSFORMER
Cable section (mm
2
) 1 mm
2
1.5 mm
2
2.5 mm
2
4 mm
2
Deimos 400
[0.116 Ohm]
5.5 m 8.3 m 13.8 m 22.1 m
Deimos 600
[0.0695 Ohm]
3.3 m 5 m 8.3 m 13.2 m
Cable section (AWG) AWG 17 AWG 15 AWG 13 AWG 11
Deimos 400
[0.116 Ohm]
5.5 m 8.3 m 13.8 m 22.1 m
Deimos 600
[0.0695 Ohm]
3.3 m 5 m 8.3 m 13.2 m
ASSEMBLE THE PANEL WITH TRANSFORMER AS PER THE MANUAL CONTAINED IN THE PACK
DEPENDING ON THE SECTION OF THE CABLE CHOSEN,
BREAK THE CABLE PASSAGE ZONE
OPEN THE COVER BY
UNSCREWING THE SCREWS

BFT DEIMOS BT A400 Specifications

General

Brand	BFT
Model	DEIMOS BT A400
Category	Transformer
Language	English

Summary

CPEM with BT A400/A600 Transformer Installation Guide

Electrical Connection System Preparation

Prepare the electrical connection system between the transformer panel and the Deimos BT A400/600.

Opening the Transformer Panel Cover

Instructions for opening the transformer panel by unscrewing the screws.

Cable Passage Zone Preparation

Prepare the cable passage zone based on the selected cable section.

Final Panel and Transformer Assembly

Assemble the panel with the transformer according to the product manual.

Detailed Installation Steps

Install Faston Connector

Insert the 6.3x0.8 female faston in the secondary of the transformer.

Cut Cable

Cut the cable as shown in the provided image.

Connect Cables

Make the connection between the cut cable and the panel's cable.

Insert Plug and Fasten Cover

Insert the plug into the socket and fasten the cover with screws.