BHM Medical Ergolift 2

Questions and Answers

B
Brandon ColeAug 12, 2025
What to do if the BHM Medical Equipment lift buttons don't work?
- C
  Cody AdkinsAug 13, 2025
  If the up or down buttons on the lift aren't working, first check if the emergency stop button is pressed down. If it is, turn the button clockwise to release it. Also, ensure the lift is plugged in to charge the battery, and check the light on the control box. If the light remains red after plugging it in, leave it plugged in for about 2 hours. If problems persist, it may be a motor or electric issue, and you should contact your BHM Medical representative.
M
mikenelsonAug 16, 2025
Why does my BHM Medical Equipment start and stop?
- H
  hansenkristenAug 16, 2025
  If your unit starts and stops repetitively, it could be due to the load exceeding the safe working limit, which triggers an overload protection on the motor, or the battery may be low. If that is the case, recharge the battery.
M
Mary RamosAug 20, 2025
What to do if BHM Medical Equipment beeps while lifting?
- M
  moorekimberlyAug 20, 2025
  If the lift beeps during use, this indicates the batteries are low. Recharge them to resolve this issue.
C
Christine HernandezAug 25, 2025
How to fix BHM Medical Equipment handset that is not working?
- A
  Andrew Wilson MDAug 25, 2025
  If the unit doesn't respond to the handset buttons, first ensure the handset is correctly plugged into the unit. If it still doesn't work, try using the control switches directly on the unit. If the control switches work, the issue lies with the handset, and it will need to be replaced.
M
Michael SandersAug 27, 2025
Why does the BHM Medical Equipment battery die quickly?
- M
  Ms. Kathleen GomezAug 27, 2025
  If the battery dies after only a few transfers, it's likely that the battery's life is nearing its end. Replace it with a new one.
M
Monica GoodAug 31, 2025
What to do if BHM Medical Equipment lift only does one or two transfers?
- J
  Jim BlevinsAug 31, 2025
  If the control box light is green but the lift only completes one or two transfers, the solution is to replace the battery.
M
Ms. Ashley Morgan DVMSep 4, 2025
Why isn't the BHM Medical Equipment charge indicator lighting up?
- L
  lauraramseySep 4, 2025
  If the charge indicator on the control box isn't lighting up during charging, first check that the charger is plugged into a standard outlet. Also, inspect the fuse and replace it if necessary.
K
Kimberly WeaverSep 8, 2025
How to fix a loose BHM Medical Equipment patient lift?
- L
  Laura CarterSep 8, 2025
  If the patient lift seems loose at the mast/base joint, use a 5 mm Allen key to tighten the 2 bolts at the base.