Bialetti Moka timer - 4. Instructions for use; First Time Use and Preparation; Manual and Programmed Operation

ES
54
5. Limpieza y mantenimiento
• No lavar en lavavajillas.
• No sumerja la parte inferior de la cafetera y la base en agua u otros líquidos.
• No limpiar con detergentes y/o materiales abrasivos.
• No coloque la cafetera sobre superfi cies calentadoras (fuego de gas, placas eléctricas,
vitrocerámica, etc.) y evite sobrecalentamientos de la base (cercanía de fuentes de
calor).
• Para no obstruir el fi ltro de la cafetera, utilice solamente polvo de café molido tradicional
para cafetera moka.
• Antes de efectuar las operaciones de limpieza, desconecte siempre el enchufe de la red
de alimentación eléctrica y espere a que el aparato se haya enfriado completamente.
• No sumerja nunca el aparato en agua.
• Para lavar el recipiente colector de la cafetera, enjuáguelo con agua corriente y después
séquelo.
• Para lavar la caldera de la cafetera, enjuague el interior y limpie las partes externas con
un paño/esponja humedecidos.
• Es aconsejable prestar atención durante el lavado de la cafetera para evitar que el agua
penetre dentro de la parte inferior del aparato donde se encuentran los componentes
eléctricos.
EN
19
4. Instructions for use
WHEN USING THE FIRST TIME
After removing the products from the box, make sure they are complete and all compo-
nents are present. Carefully wash the coffee maker before using it for the fi rst time. Make
3 coffees and discard them.
Coffee Maker
Filling/preparation procedure
• Unscrew the collecting unit.
• Extract the funnel from the heater.
• Pour the water into the heater up to the lower level of the safety valve.
• Insert the funnel into the heater.
• Fill the fi lter with moka ground coffee without pressing, avoiding to leave coffee powder
on the heater edge.
• Screw back the collecting unit without taking it from the handle and place the coffee
maker on its power base.
Instructions for use
Manual start:
• Connect the base to a mains outlet.
• Make sure to have previously prepared the coffee maker.
• Press the button “11”, the base goes on and starts heating, at the same time the tem-
perature maintenance function is activated and is shown on the display. The function ca
be disabled by pressing the button “9”.
• Press the button “11” again to stop the functioning.
• When the coffee is ready, the base emits a sound to alert the user, the temperature
maintenance function is activated automatically and can be disabled by pressing the
button “9”.
• When the coffee is ready, an acoustic warning signal is activated.
• The coffee is kept warm up to 30’ from the base switching on.
• To serve the coffee, lift the coffee maker off the base and pour its content into the coffee
cups.
Programmed start:
• Connect the base to a mains outlet.
• Make sure to have previously prepared the coffee maker.
• To set the programmed start, it is necessary to set the correct time by following the
instruction in the paragraph “Clock Function”.
• After having set the time, press the MODE button: