Safety Notes
Please remember that this
new member of your home/
oce is an electrical appliance.
Accordingly, to keep both
you and your BIBO bar
working together in harmony,
some safety stuff need to be
followed. Please remember:
Your BIBO bar is for indoor use
only.
Avoid placing your BIBO bar
in direct sunlight or next to
flammable materials.
Avoid placing your BIBO bar
near other appliances that
could get damaged if wet.
Do not immerse your BIBO bar
in water.
Your BIBO bar uses 230VAC
voltage and should be used
with a 3-pin plug.
Warning: the BIBO bar must be
used with a reliable earth in the
mains power supply socket.
Ensure that your water feed/
supply is flushed out thoroughly
into a bucket until clear water
is visible with no sediments or
dirt particles in the water. This
is to ensure your BIBO bar does
not block up. Be sure to do so
especially on newly renovated
homes and oces.
Ensure that your water feed/
supply is a cold water feed
only.
It is important that, when using
a new or freshly cleaned BIBO
bar for the first time, the water
is flowing freely through both
the hot and cold water outlets
before switching the hot water
tank on.
When your BIBO bar is
turned on for the first time,
we recommend running 1-1,5
litres of water through it before
drinking the water. This makes
sure that the water is at its
freshest.
Your BIBO bar can produce
high temperature boiling water.
As with any kettle, pan or
appliance capable of producing
boiling water, please exercise
caution.
Your BIBO bar’s hot tank is
directly connected to the hot
water outlet with no valves
between the tank and the hot
water outlet. This it to prevent
the valves from being damaged
by the boiling water. As such,
it is normal for a small amount
of excess water to be released
after the boiling water has been
dispensed. Please take caution.
If you’re looking for a little
more technical information
or explanations regarding
your trusty BIBO bar, please
don’t hesitate to get in
touch with us via email at
help@bibo.co.za.
To Next Page
Loading...