7
ATTACHING ACCESSORY DRAWER TO
EXTENSION TABLE
frame’s metal glider.
and line up four holes in drawer frame — two shown at
the extension table.
Attach the frame to the bracket using four 1/4-20 x 1/2”
6 and tighten underneath with flange nut.
NOTE: Do not re-insert drawer until the table is turned
right side up and attached to the saw.
ATTACHING HANDLE TO DRAWER
and attach handle to the drawer face with two #8-32 x
H
FIG. 5
I
FIG. 6
I
K
FIG. 7
L
FIG. 7C
DRAWER STORAGE FOR ACCESSORIES
of the accessories that come with your Unisaw.
P
FIG. 7A
FIG. 7B
N
M
M
J
To Next Page