Silicon pads
Silicon pads
FIG 1.
FIG 2.
FIG 3.
FIG 4.
FIG 5.
Unpack the unit and remove the outer packaging. Then place the
unit on a flat and stable surface.
1. Now open the baking chamber of the unit. (FIG. 1.)
2. Remove the cardboard spacer inserts. (FIG. 2.)
3. Tilt the two baking tins forward or backward slightly and lift them
out of the bread-maker. (FIG. 3.)
4. Below the tins, there are four pairs of silicon pads in recesses in
the base, as shown at the left. (FIG. 4. and FIG. 5.)
5. Grasp the silicon pads with your fingers and remove them. You
may need to loosen the silicon pads, e.g. with the aid of a tooth-
pick. (FIG. 4.)
6. The removed silicon pads (8 pieces) are shown in FIG. 6..
FIG 6.
(8 pieces)
FIG. 5. Overhead view of the
open bread-maker
Before using your bread-maker …
In order to ensure the safe transport of your new automatic bread-maker, the
unit contains transport safety devices that must be removed before use.
To Next Page
Need help?
General
