test
B. Turn off the main supply to the receiver for more than 30 seconds and turn on the main supply to receiver again.
Press and hold the SET button on the remote for 6 seconds within 60 seconds of turning the power on to the
receiver.
C. Press the buttons on the remote to run the fan. In general, performing point A, B, and C should repair the remote
and receiver and will allow full control of the fan. If not, please do the next step.
D. The DIP switches on the fans are set up at the factory. The DIP switch can be changed to any location in 16 options.
(Eg. up-up-down-down).
To Next Page
Loading...
