BIG RED JACKS TORIN T83002

Questions and Answers

S
Steven PhamJul 27, 2025
Why BIG RED JACKS TORIN T83002 will not lift load?
- C
  Charles ConleyJul 27, 2025
  Your BIG RED JACKS Lifting System might fail to lift a load due to several reasons. It's possible that the weight capacity has been exceeded. Another cause could be air trapped in the hydraulics, in which case you should purge the air from the system. A low oil level could also be the culprit, so check and add oil as needed. Finally, the power unit itself might be malfunctioning, requiring a replacement.
R
Richard DiazAug 2, 2025
What to do if BIG RED JACKS Lifting Systems has poor lifting?
- J
  Jessica WilkinsonAug 2, 2025
  If your BIG RED JACKS Lifting System demonstrates poor lifting performance, it could be due to a few reasons. First, there might be air in the hydraulics, so try purging the air from the system. Secondly, check the oil level and add oil if it's low. Lastly, the power unit may be malfunctioning, and you might need to replace it.
J
Jason FlowersAug 9, 2025
Why BIG RED JACKS TORIN T83002 will not hold load?
- R
  Roger SloanAug 9, 2025
  If your BIG RED JACKS Lifting System isn't holding the load, it might be due to a low oil level, so you should add oil as required. Another potential cause is a malfunctioning power unit, which would need to be replaced.
K
Kevin BowmanAug 14, 2025
How to fix if BIG RED JACKS TORIN T83002 Lifting Systems will not lower?
- T
  Tina JonesAug 15, 2025
  If your BIG RED JACKS Lifting System won't lower, it could be because the release valve isn't completely closed. Turn the handle clockwise to ensure it's fully closed. Alternatively, the oil reservoir might be overfilled; drain the excessive oil and lubricate the moving parts. Another reason can be binding or a foreign obstruction.
M
Michelle PowellAug 21, 2025
Why BIG RED JACKS Lifting Systems will not lift to full extension?
- R
  Rebecca HarrisAug 21, 2025
  If your BIG RED JACKS Lifting System isn't lifting to its full extension, it could be because the oil level is low, so add oil as required. Alternatively, the power unit might be malfunctioning, in which case you should replace it.