深圳市必趣科技有限公司
BIG TREE TECH
4.When the data displayed on the screen or serial port is not
normal, please remove the closed-loop driver board and check
whether the magnet of the motor shaft is in the center. If it
is not, please recalibrate. After calibration, set parameters
after initialization(1-2s).
5.Do not turn the motor manually after power on.
6.The distance between the magnet of the motor shaft and the
magnetic coding chip is more than 2mm.
7.Please ensure that the structure of 3D printer is stable.
Should you have any issues, please don't hesitate to contact us. We
strive to provide you with the best quality products and services. If
you have any good comments or suggestions, please feel free to
share with us. Thank you for choosing BIGTREETECH products!
To Previous Page
Loading...
